DATAFLEX
®
110/...
Torque Measuring Shaft
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
49018 EN
11 of 22
1
Please observe protection
note ISO 16016.
Drawn:
2017-08-02 Pz/Da
Replacing:
---
Verified:
2017-08-03 Pz
Replaced by:
!
With the assembly please make sure that the lamina sets are installed free from distortion in
axial direction. Disregarding this advice may cause damage to the coupling.
•
Insert the lamina sets and the DATAFLEX
®
measuring shaft.
•
Hand-tighten the components for the time being, with the fit bolts being assembled displaced from left to right
(see illustration 11).
•
Tighten the fit bolts to the tightening torques mentioned in table 6 by means of a suitable torque key.
Illustration 11: Assembly of lamina sets, RADEX
®
-N size 135
!
With the assembly please make sure that the lamina sets are installed free from distortion in
axial direction. Disregarding this advice may cause damage to the coupling.
•
Insert the lamina sets and the DATAFLEX
®
measuring shaft.
•
Hand-tighten the components for the time being, with the fit bolts being assembled displaced from left to right
(see illustration 12). With size 156 use a washer under the screw head.
•
The pressure screws in the clamping nut must not protude on the pressure side (see illustration 13).
!
All components must be superimposed without any gap.
•
Afterwards turn back the clamping nut until there is a gap of 1 - 2 mm (see illustration 13).
•
Hand-tighten the pressure screws marked in illustration 15.
•
Tighten these screws (see illustration 15) at half the tightening torque according to table 6 and afterwards at
the full tightening torque according to table 6.
•
Now tighten all pressure screws one after another and with several revolutions until all screws have achieved
the full tightening torque (illustration 16).
!
The pressure screws must not bear on the heads after assembly (see illustration 14).
•
All clamping nuts have to be mounted as per the aforementioned process.
4
Assembly
4.7 Assembly of the lamina sets, RADEX
®
-N size 135
4.8 Assembly of the lamina sets, RADEX
®
-N size 156
