KTR Kupplungstechnik
GmbH
D-48407 Rheine
C L A M P E X
®
K T R 6 0 3
m o u n t i n g i n s t r u c t i o n s
KTR-N
sheet:
edition:
40821 E
2
1
Gezeichnet: 10.07.01 Sha/Hg
Ersatz für:
Verteiler
Urheberschutz
gemäß DIN 34
Geprüft:
13.07.01 Sha
Ersetzt durch:
W
K
V
VA
M KC
The clamping set is generally delivered in assembled condition.
Tolerances, surfaces
A good rotating process is sufficient:
Highest permissible tolerance:
Rz
≤
16
µ
m
d = h8 for the hub
(hollow shaft outside)
Components of CLAMPEX
®
KTR 603
component
quantity
designation
1
1
front external ring (with through holes)
2
1
back external ring (with tappings)
3
1
internal ring (slotted)
4
see catalogue hexagonal screws DIN 933
picture 1: CLAMPEX
®
KTR 603
F
A T T E N T I O N !
Dirty or used clamping sets must be disassembled before the installation in order to be
cleaned. Afterwards only the taper surfaces and the clamping screws must be greased with
Molykote MoS
2
(see picture 2).
Assembly
•
Check the shaft and hub position regarding the permitted tolerance (see table 1).
•
The contact surfaces of shaft / hollow shaft inside and shaft must be cleaned and degreased.
picture 2
!
C A U T I O N !
Contact surfaces of shaft and hub bore (hollow shaft inside) must neither be greased
nor be oiled (see picture 2).
