KTR Kupplungstechnik
GmbH
D-48407 Rheine
C L A M P E X
®
K T R 2 2 5
m o u n t i n g i n s t r u c t i o n s
KTR-N
sheet:
edition:
40816 E
3
3
Gezeichnet: 08.01.03 Sha/Hg
Ersatz für:
KTR-N 40822
Verteiler
Urheberschutz
gemäß DIN 34
Geprüft:
08.01.03 Sha
Ersetzt durch:
W
K
V
VA
M KC
Assembly
Continuation:
•
Tighten the clamping screws evenly and crosswise. Increase the tightening torque step by step.
This procedure must be repeated until the tightening torque indicated in table 1 is reached with all
clamping screws.
Table 1:
type of clamping set
screw size M
tightening torque T
A
[Nm]
225
M8
41
Disassembly
STOP
D A N G E R !
Loosened or falling drive parts can cause injuries to persons or damages to the
machines.
Safe the drive parts before the disassembly.
•
Loose all clamping screws evenly one after the other and unscrew them.
•
Screw the clamping screws into the threads of the internal ring (component 2).
•
Tighten the clamping screws evenly and crosswise. Increase the tightening torque step by step
until the external ring (component 1) and the internal ring (component 2) are separated.
•
Remove the unscrewed clamping set between shaft and hub.
picture 2: unscrew the clamping set KTR 225
!
C A U T I O N !
In case of non-observance of these hints or in case of non-considerance of the
operating conditions regarding the selection of the clamping set, the function of the
clamping set can be influenced.
Disposal of waste:
Defective clamping sets must be cleaned and scrapped.
