KTR-STOP
®
S-xx-F B-xx
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
44590 EN
13 of 26
3
Please observe protection
note ISO 16016.
Drawn:
2018-09-10 Shg/Wie
Replacing:
KTR-N dated 2018-02-07
Verified:
2018-09-10 Shg
Replaced by:
The centering systems need to be reset with initial assembly or after having replaced brake
pads or single parts, respectively. This is the only way to ensure that the gap between the
brake disk and the brake pad on the bottom side is set to the right value and the pad does
not touch on any side.
The centering systems need to be regularly reset with wear of the brake pads. For that pur-
pose repeat the complete chapter
Setting/resetting of the centering system
.
Measure the gap between the brake disk and the brake pad on the bottom side via a feeler gauge.
Set the gap to 0.5 mm (see illustration 12) by screwing the pin (component 5.1) either upwards or down-
wards.
Secure the pin (component 5.1) via the hexagon nut (component 5.2).
Screw the cap screws (component 4.1) into the base plate (component 3.1). The screw depth in the base
plate must be 20 mm
(Only valid with a thickness of brake disk of 20 mm: screwing depth must be 30
mm).
Seal the bores via the sealing plugs (component 4.4 and 5.3).
Illustration 12: Setting of gap
Illustration 13: Setting of centering system
The gap between brake disk and brake pad needs to be 0.5 mm on both sides to ensure the
brake power.
4
Assembly
4.5 Setting/resetting of the centering system
