KTR-STOP
®
S-A-F B-xx
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
44591 EN
21 of 24
5
Please observe protection
note ISO 16016.
Drawn:
2019-08-13 Pz/Mro
Replacing:
KTR-N dated 2018-12-04
Verified:
2019-08-13 Pz
Replaced by:
!
Oils and greases containing molybdenum disulphite or zinc sulphite additives must not be
used.
Illustration 20: Assembly of gasket and scraper
Illustration 21
!
Inspect the surfaces of the brake piston and the hole of the piston cover to make sure that
they are neither scratched nor damaged, since the surfaces are either ground or polished.
Such kind of damages may cause earlier wear on the gaskets and scrapers and generate
leakages.
•
Insert the brake piston (component 1.8) into the caliper and press it against a stop.
•
Depending on the thickness of brake disk:
Fit the spacer plate (component 2). Please conclude position and number of spacer plate from the customer
drawing.
•
After having disassembled the pin of the internal centering system (component 5.1), screw the pin (component
5.1) into the brake caliper. Afterwards screw the hexagon nuts (component 5.2) onto the pin.
•
Fit the pre-assembled unit carefully onto the guide pins.
Please make sure that the centering system (component 5) is not damaged.
5
Maintenance
5.2 Maintenance of the brake / replacement of single parts