CLAMPEX
®
KTR 130 / KTR 131
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
40829 EN
6 of 7
4
Please observe protection
note ISO 16016.
Drawn:
2016-12-22 Shg/Jh
Replacing:
KTR-N dated 2014-09-18
Verified:
2016-12-22 Shg
Replaced by:
Please inspect shaft and hub fit for the tolerance specified (h8/H8).
Clean the hub bore and shaft and afterwards apply a thin-fluid oil (e. g. Ballistol Universal oil or Klüber Qui-
etsch-Ex).
!
Oils and greases with molybdenum disulphide or high-pressure additives, additives of Tef-
lon and silicone as well as internal lubricants reducing the coefficient of friction significantly
must not be used. When mounting the tapers of the clamping set free from oil the tabular
and calculated parameters deviate.
Release the hexagon nut (component 1) and insert the clamping set KTR 130/KTR 131 between shaft and
hub.
Lightly tighten the hexagon nut and align clamping set and hub components.
Tighten the hexagon nut at the tightening torque T
A
specified in table 1.
During assembly the hub is displaced axially towards the shaft.
Clamping set KTR 131 with counter hexagon bolt for clamping on lightly twistable shafts.
Illustration 5: Clamping set KTR 130 fully assembled
Illustration 6: Clamping set KTR 131 fully assembled
STOP
Driving components released or falling down may cause injury to persons or damage on the
machine.
Secure the driving components before disassembly.
Release the hexagon nut (component 1).
Turn the hexagon nut left until the clamping set KTR 130/KTR 131 can be shifted on the shaft.
Take out the clamping set released between shaft and hub.
4
Assembly
4.2 Assembly of the clamping set
4.3 Disassembly of clamping set
