KTM Freeride 250 R EU, Руководство пользователя

Страница: 90 / 115

18 SERVICE WORK ON THE ENGINE
88
18.2 Checking the gear oil level
Info
The gear oil level must be checked when the engine is cold.
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
B01669-10
Main work
–
Remove the gear oil monitoring screw  .
–
Check the gear oil level.
A small quantity of gear oil must run out of the drilled hole.
» If no gear oil runs out:
–
Add gear oil. ( p. 89)
–
Mount and tighten the gear oil monitoring screw.
Guideline
Screw, gear oil level check M6 10 Nm (7.4 lbf ft)
18.3 Changing the gear oil
400721-01
–
Drain the gear oil. ( p. 88)
400722-01
–
Fill in gear oil. ( p. 89)
18.4 Draining the gear oil
Warning
Danger of scalding
Engine oil and gear oil get very hot when the motorcycle is ridden.
–
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Drain the gear oil while the motor is warm.
Preparatory work
–
Park the motorcycle on a level surface.
–
Place a suitable container under the engine.