KTM Freeride 250 R AUS 2014, Руководство по ремонту

Страница: 35 / 222

7 HANDLEBAR, CONTROLS
33
7.4 Checking the throttle cable routing
Preparatory work
–
Fold the seat up. ( p. 62)
–
Remove the fuel tank. ( p. 65)
B01712-10
Main work
–
Check the throttle cable routing.
The throttle cable must be routed to the carburetor along the back of the handle-
bar, below the seat fixing.
» If the throttle cable is not routed as specified:
–
Correct the throttle cable routing.
Finishing work
–
Install the fuel tank. ( p. 65)
–
Lock the seat. ( p. 62)
7.5 Checking the play in the throttle cable
400192-11
–
Check the throttle grip for smooth operation.
–
Move the handlebar to the straight-ahead position. Turn the throttle grip back and
forth slightly and determine the play in throttle cable
A
.
Throttle cable play 2… 3 mm (0.08… 0.12 in)
» If the throttle cable play does not meet specifications:
–
Adjust the play in the throttle cable. ( p. 34)
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result
in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
–
Start the engine and let it run idle. Move the handlebar to and fro over the entire
steering range.
The idle speed must not change.
» If the idle speed changes:
–
Adjust the play in the throttle cable. ( p. 34)