KTM F9903U4, Руководство пользователя

Страница: 119 / 192

SERVICE WORK ON THE CHASSIS 13
117
13.34 Removing front fender
E02253-11
–
Open holder
1
and detach the brake lines and cable.
–
Remove screws
2
.
–
Take the fender off to the front.
Info
Pay attention to the brake lines and the cable.
13.35 Installing front fender
E02253-10
–
Position the fender.
Info
Pay attention to the routing of the brake lines and the
cable.
–
Mount and tighten screws
1
.
Guideline
Screw, fender M5x12 3.5 Nm
(2.58 lbf ft)
–
Insert the brake lines and cable in brackets
2
and close the
holder.
13.36 Cleaning the dust boots of the fork legs
Preparatory work
–
Raise the vehicle with the center stand. ( p. 96)
–
Remove front fender. ( p. 117)
E02251-10
Main work
–
Push dust boots
1
of both fork legs downward.
Info
The dust boots remove dust and coarse dirt particles
from the inside fork tubes. Over time, dirt can accumu-
late behind the dust boots. If this dirt is not removed,
the oil seals behind can start to leak.
Warning
Danger of accidents
Oil or grease on the brake discs
reduces the braking effect.
–
Always keep the brake discs free of oil and grease.
–
Clean the brake discs with brake cleaner when nec-
essary.
–
Clean and oil the dust boots and inner fork tubes of both fork
legs.