KTM F8203S2, Инструкции по установке

Страница: 29 / 48

WORK 3
27
3.11 Removing the seat
V00342-10
–
Remove screws
1
.
–
Raise the rear of the seat, pull the seat back, and lift it off.
3.12 Mounting the seat
V00343-10
–
Mount the front of the seat on the collar bushing of the fuel
tank, lower the seat at the rear, and push the seat forward.
–
Make sure that the seat is correctly locked in.
V00342-10
–
Mount and tighten screws
1
.
Guideline
Remaining screws,
chassis M6 10 Nm (7.4 lbf ft)
3.13 Removing the battery
Note
Environmental hazard Batteries contain environmentally-hazardous materials.
–
Do not dispose of batteries as household waste.
–
Dispose of batteries at a collection point for used batteries.
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with
the applicable regulations.
Preparatory work
(EXC
‑
F EU/AU/BR, All Six Days models)
–
Press and hold the kill switch while the engine is idling
until the engine stops.
(EXC-F US)
–
Turn the key in the ignition lock to the position while the
engine is idling.
–
Remove the seat. ( p. 27)