KTM F7303U2, Инструкции по установке

Страница: 29 / 51

WORK 3
27
V00364-11
–
Mount and tighten screw
2
.
Guideline
Screw, front wheel
spindle M20x1.5 35 Nm (25.8 lbf ft)
–
Operate the hand brake lever several times until the brake lin-
ings are seated correctly against the brake disc.
–
Remove the motorcycle from the lift stand. ( p. 19)
–
Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
Tighten screws
3
.
Guideline
Screw, fork stub M8 15 Nm (11.1 lbf ft)
3.11 Removing the 12-V battery
Note
Environmental hazard
12 V batteries contain environmentally hazardous materials.
–
Do not dispose of 12 V batteries as household waste.
–
Dispose of 12 V batteries at a collection point for used batteries.
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with
the applicable regulations.
Preparatory work
–
Remove the seat. ( p. 19)
S03489-10
Main work
Warning
Risk of injury 12 V batteries contain harmful sub-
stances.
–
Keep 12 V batteries out of the reach of children.
–
Keep sparks and open flames away from 12 V bat-
teries.
–
Only charge 12 V batteries in well-ventilated
rooms.
–
Maintain a minimum clearance from inflammable
materials when charging 12 V batteries.
Minimum clearance
1 m (3 ft)
–
Do not charge deeply discharged 12 V batteries if
the charge is already below the minimum voltage.
Minimum voltage before
the start of the charge
9 V
–
Dispose of 12 V batteries with less than the mini-
mum voltage correctly.
–
Disconnect negative cable
1
from the 12-V battery.