KTM BDU3740, Руководство по эксплуатации

Страница: 9 / 40

En
glish – Pa
ge 7
￭ You are urgently advised to make a note of the key number.
The key number can be noted on the last page of the original operating instructions in the bicycle registration
document and in the handover certificate. If you lose the key, you can use the key number to order a replacement
from your KTM dealer.
Disposal
A used battery or defective electrical components must be disposed of properly.
Used batteries and electrical components, such as drive units, head lights, rear lamps and hub dynamos,
must not be placed with household waste – please recycle them or return them to a KTM dealer. For detailed
information on the disposal of EPAC components, refer to the chapter on the
“Bosch drive system” .
Transport and loading
￭ Overloading may cause the EPAC components to deform or break.
￭ The battery may ignite or even explode if its protective circuit and protective mechanism become
damaged. This may present a mortal danger. For this reason, remove the battery when transporting
it by car.
￭ Attach a cap or another safety appliance to protect the battery contacts from unintentional short
circuit.
Never take a passenger on your EPAC (exception: carrying a small child in a child seat).
Pay attention to the maximum permissible weight – refer to the chapter on “Intended use” .
￭ Make sure that you remove the battery before transporting the EPAC by or in a car.
Contact with liquids can cause heat, fire, explosion and smoke due to damage to the protective circuit and protective
mechanism of the battery.
￭ Adhere to the applicable regulations on hazardous goods when transporting the battery.
Transporting an EPAC battery may be legally classified as a transport of hazardous goods. Familiarise yourself with the
applicable regulations on hazardous goods before transporting the EPAC battery. Any violation of these regulations is
an administrative offence and can lead to fines.
￭ Exclusively use suitable bike carriers (roof or tail racks) to transport your EPAC by car.
Not all bicycle bike are suitable for the safe transport of EPACs due to the position of the drive components, the
special frame shape and the increased weight of EPACs. When transporting an EPAC, an unsuitable bike carrier may
be damaged or break and therefore cause accidents. An unsuitable bike carrier may also damage the EPAC. After
transporting the EPAC by car, check the plug connections for moisture and allow them to dry before putting the
bicycle back into operation.
￭ Be aware that driving characteristics may change significantly due to additional load.
Pay attention to the maximum permissible weight for your EPAC during loading – refer to the chapter on “Intended
use” . Keep the load symmetrical at all times.
￭ Only use child seats that are suitable for mounting on your EPAC.
Driving characteristics may change significantly due to additional load – refer to the chapter on “Intended use” . Your
child should wear a tested child helmet.
￭ Only use bicycle or child trailers that are suitable for attachment to your EPAC.
The position of the drive components and the special frame form mean that not all bicycle or child trailers are suitable
for attachment to the frame. You and your child may suffer accidents with very severe injuries if you use an unsuitable
bicycle or child trailer. Your KTM dealer will gladly assist you in selecting a suitable trailer. Your child should wear a
tested child helmet at all times.