KTM 990 Adventure AUS/UK 2012, Инструкции по установке

Страница: 11 / 16

3 WORK
9
Warning
Environmental hazard Improper handling of fuel is a danger to the environment.
–
Do not allow fuel to get into the ground water, the ground, or the sewage system.
302078-10
–
Lift the cover
1
of the filler cap and insert the ignition key in the lock.
Note
Danger of damage
Ignition key breakage.
–
To take pressure off of the ignition key, push down on the filler cap. Damaged
ignition keys must be replaced.
–
Turn the ignition key 90° clockwise.
–
Raise the filler cap, withdraw the ignition key and open the second filler cap.
–
Remove the ignition key.
Info
The motorcycle is equipped with two fuel tanks and two filler necks. The
fuel tanks are connected to each other with a fuel line that equalizes the
fuel level.
The two filler caps are equipped with a ventilation system.
3.8 Closing the filler caps
100515-10
Warning
Fire hazard Fuel is highly flammable, poisonous and harmful to your
health.
–
When closing the filler cap, ensure that it is closed correctly. Change
clothing that came into contact with fuel. Immediately clean skin that
came into contact with fuel using soap and water.
–
Push the filler caps closed until the locks engage.
–
Close the covers.
3.9 Adjusting the ignition curve to the fuel quality
Preparatory work
–
Switch off the ignition by turning the black ignition key to the position OFF .
–
Remove the seat. ( p. 6)
To activate the ignition curve for low octane fuel:
Note
Engine failure Low-quality fuel damages the engine.
–
Operate the vehicle with fuel with an octane rating below 95 (ROZ 95/RON 95/PON 91) for no more than one tank full.
–
The ignition curve must be adjusted to low octane fuel.
–
Disconnect plug-in connector
1
.
Plug-in connector disconnected
–
Fuel with an octane rating of 80 to 94 (RON) can be used for one tank full.
Activate the ignition curve for fuel with an octane rating of 95 or higher (ROZ 95 / RON 95 / PON 91):
–
Connect plug-in connector
1
.
Plug-in connector connected
–
Fuel with an octane rating of 95 or higher can be used.
Finishing work
–
Mount the seat. ( p. 6)