KTM 990 Adventure AUS/UK 2012, Инструкции по установке

Страница: 8 / 16

3 WORK
6
3.1 Removing the seat
100516-10
–
Insert the ignition key into the seat lock.
–
Turn the ignition key to position
C
.
–
Lift up the seat at the rear, pull it back and remove from above.
–
Remove the ignition key.
3.2 Mounting the seat
0 0 3 3 0 0 1 1 0 0 2 2
100505-10
–
Hook projection
1
of the seat into the storage compartment, lower the seat at the
rear and push it forward at the same time. The two projections
2
must be inserted
into the frame.
–
Push locking pin
3
into the lock housing and push the back of the seat down until
the locking pin locks in place with an audible click.
–
Finally, check that the seat is correctly mounted.
3.3 Removing the right underride guard
100581-10
–
Remove screws
1
. Remove the right underride guard
2
.
3.4 Installing the right underride guard
100581-11
–
Position right underride guard
1
. Mount and tighten screws
2
.
Guideline
Remaining chassis screws M6 10 Nm (7.4 lbf ft)
3.5 Recharging the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open flames. Charge only in well-ventilated areas.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.