KTM 690 SUPERMOTO AUS Packaging 5 2008, Инструкции по установке

Страница: 9 / 14

WORK
7
100151-10
–
Connect the battery charger to the battery. Switch on the battery charger.
Battery charger (58429074000)
You can also use the battery charger to test rest potential and start potential of the
battery, and to test the generator. With this device, you cannot overcharge the bat-
tery.
Info
Never remove the lid

.
Charge the battery according to the instructions

on the battery casing.
–
Switch off the charger after charging. Disconnect the battery.
Guideline
The charge current, charge voltage and charge time must not be exceeded.
Charge the battery regularly when the
motorcycle is not in use.
3 months
–
Position the fuel tank. ( S. 5)
–
Mount the seat. ( S. 5)
–
Set the clock. ( S. 7)
3.6
Setting the clock
Condition
The motorcycle is standing.
700115-10
–
Switch on the ignition by turning the ignition key to the position (690 SUPER-
MOTO R USA).
–
Press the MODE button several times until the ODO display mode is active.
–
Keep the MODE button and the SET button pressed simultaneously.
The time begins to flash.
–
Press the MODE button to adjust the hour.
–
Press the
SET
button to adjust the minute.
–
Keep the
MODE
button and the
SET
button pressed simultaneously.
The time is set.
3.7
Setting kilometers or miles
Info
If you change the unit, the ODO value is retained and converted accordingly.
Making the setting according to the country.
Condition
The motorcycle is standing.
700120-01
–
Switch on the ignition by turning the ignition key to the position (690 SUPER-
MOTO R USA).
–
Press the MODE button several times until the ODO display mode is active.
–
Keep the MODE button pressed until the display mode changes from Km/h to Mph or
from Mph to Km/h .
Guideline
Activation duration of MODE button 10 s