KTM 690 SMC R AU 2014, Инструкции по установке

Страница: 8 / 18

3 WORK
6
3.1 Removing the seat
101977-10
–
Pull on strap

and raise the rear of the seat at the same time.
–
Pull back the seat and lift it off.
3.2 Mounting the seat
101988-10
–
Hook slot

of the seat onto screw

, press the rear downward and at the same time push it forward.
–
Push locking pin

into lock housing

and push the back of the seat down until the locking pin locks in place with an audible
click.
–
Finally, check that the seat is correctly mounted.
3.3 Removing the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. ( p. 6)
B01974-10
Main work
–
Remove battery cover  .
–
Pull the EFI control unit

off of the holder and set it to one side.