KTM 690 SMC EU, Инструкции по установке

Страница: 8 / 19

3 WORK
6
3.1 Removing the seat
101977-10
–
Pull on strap
1
and raise the rear of the seat at the same time.
–
Pull back the seat and lift it off.
3.2 Mounting the seat
101988-10
–
Hook slot
1
of the seat onto screw
2
, press the rear downward and at the same time push it forward.
–
Push locking pin
3
into lock housing
4
and push the back of the seat down until the locking pin locks in place with an audible
click.
–
Check, finally, that the seat is correctly mounted.
3.3 Removing the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
Preparatory work
–
Switch off the ignition by turning the ignition key to position OFF .
–
Remove the seat. ( p. 6)
B01974-10
Main work
–
Remove battery cover 1 .
–
Pull engine electronics control unit
2
off of the holder and set it to one side.