KTM 690 SMC 2008, Руководство по ремонту

Страница: 28 / 227

01/FORK, TRIPLE CLAMP
26
600636-10
–
Move the handlebar to the straight-ahead position. Move the fork legs to and fro in
the direction of travel.
No play should be noticeable in the steering head bearing.
» If there is noticeable play present:
–
Adjust the play of the steering head bearing. ( p. 26)
–
Move the handlebar to and fro over the entire steering range.
The handlebar must be able to move easily over the entire steering range. No
resting locations should be noticeable.
» If click positions are noticeable:
–
Adjust the play of the steering head bearing. ( p. 26)
–
Check the steering head bearing and change if necessary.
–
Remove the motorcycle from the work stand.
5.14
Adjusting the steering head bearing play
–
Raise the motorcycle and secure it against falling over.
The front wheel is no longer in contact with the ground and the fork legs are no
longer under tension.
100297-10
–
Loosen screws

. Remove screw

.
–
Loosen and retighten screw

.
Guideline
Screw, top steering head M20x1.5 10 Nm (7.4 lbf ft)
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
–
Fully tighten screw

.
Guideline
Screw, top triple clamp M8 17 Nm
(12.5 lbf ft)
–
Mount and tighten screw

.
Guideline
Screw, steering stem M8 20 Nm
(14.8 lbf ft) Loctite ® 243™
–
Check the steering head bearing play. ( p. 25)
–
Remove the motorcycle from the work stand.