KTM 65 SX 2011, Инструкции по установке

Страница: 5 / 13

SET
‑
UP
3
2.1
Unpacking and setting up the vehicle
700529-01
–
Open the box.
Info
To avoid damaging the vehicle during assembly, do not remove the protec-
tive plastic from a part until just before mounting it and leave the plastic
sheeting on the vehicle until work is completed.
–
Remove the front wheel, fender, hand protectors, and enclosed package from the
box.
–
Remove the separate enclosure and unpack it. Check that the scope of delivery is
complete on the basis of the enclosed packing list.
–
Lift the vehicle out of the box with the help of another person.
–
Raise the motorcycle with a lift stand. ( p. 4)
–
Check the vehicle for transport damage.
700530-01
–
Remove screw

.
–
Loosen screws

.
–
Remove the wheel spindle.
–
Install the front wheel. x ( p. 4)
–
Remove the protective plastic from the handlebar.
700531-01
–
Position the handlebar with handlebar clamps

.
–
Mount and tighten the screws.
Guideline
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
–
Check the handlebar position.
» If the handlebar position is not adjusted as the customer requires:
–
Adjust handlebar position.
x
( p. 5)
–
Install the front fender. ( p. 5)
–
Check the wiring harness, throttle cables and brake line for free movement and cor-
rect routing.
–
Check that all controls on the handlebar are in the correct location and seated
firmly.
800042-10
–
Mount the footrests with the springs and bolts. Secure the bolts using the washers
and pins.
Plier for footrest spring (58429083000)
–
Fill up with fuel. ( p. 6)
–
Print out the current PDI form found on KTM DEALER.NET and perform the delivery
inspection.