KTM 65 SX 1999, Руководство пользователя

Страница: 35 / 91

11 SERVICE WORK ON THE CHASSIS
33
H00155-10
–
Mount and tighten screw

.
Guideline
Screw, steering stem M8 20 Nm
(14.8 lbf ft)
–
Position fuel tank breather

.
H00155-11
–
Tighten screws

.
Guideline
Screw, top triple clamp M8 20 Nm
(14.8 lbf ft)
K00218-10
–
Position the brake caliper, and mount and tighten screws

.
Guideline
Screw, brake caliper M8 20 Nm
(14.8 lbf ft) Loctite ® 243™
–
Position the brake line and clamp. Mount and tighten screws

.
Finishing work
–
Check that the wiring harness, throttle cables, and brake and clutch lines can move
freely and are routed correctly.
–
Install the front fender. ( p. 35)
–
Install the start number plate. ( p. 35)
–
Install the front wheel. ( p. 58)
–
Check play of steering head bearing. ( p. 33)
–
Remove the motorcycle from the lift stand. ( p. 28)
11.11 Checking play of steering head bearing
Warning
Danger of accidents Unstable vehicle handling from incorrect steering head bearing play.
–
Adjust the steering head bearing play without delay. (Your authorized KTM workshop will be glad to help.)
Info
If the bike is ridden with play in the steering head bearing, the bearing and the bearing seats in the frame can become dam-
aged over time.
Preparatory work
–
Raise the motorcycle with a lift stand. ( p. 28)
400738-11
Main work
–
Move the handlebar to the straight-ahead position. Move the fork legs to and fro in
the direction of travel.
No play should be noticeable in the steering head bearing.
» If there is noticeable play present:
–
Adjust the steering head bearing play. ( p. 34)