10
Preassembly
- Position tail light
on base support
(both included).
- Mount screws
(included) and tighten to 2 Nm.
- Mount rubber grommet
(included).
- Position license plate lighting
on EU license plate holder
(both included) or USA license plate holder
.
- Position the bracket for re
fl
ector
with screws
(all included) on
EU license plate holder
.
- Mount re
fl
ector
(included) on the bracket for re
fl
ector
.
NOTE
The further steps are the same on both license plate holders. The
example shown is the EU license plate holder
.
- Position the original turn signal.
- Mount and tighten nuts
with the washers.
NOTE
Right turn signal = green adhesive tape on the cable
Left turn signal = red adhesive tape on the cable
Optional
- Position the LED turn signal.
- Mount and tighten nuts
with the washers (included with LED
turn signal).
- Mount protection caps
(included with LED turn signal).
- Plug in resistances
(included with LED turn signal).
ENGLISH
