ENGLISH
21
MAINTENANCE WORK ON CHASSIS AND ENGINE
»
Removal of seat (LC4 Supermoto)
Actuate the lever
[1]
while lifting the back of the seat
[2]
.
When you mount the seat, make sure the retaining brackets are fastened to
the seat.
Tool set (LC4 Supermoto)
The tool set
[3]
is located under the seat.
Checking and adjusting steering head bearing *
Check steering head bearing for play periodicaly. To check this put motorcy-
cle on a stand so that the front wheel is off the ground. Now try to move the
fork forward and backward. To adjust, loosen the five clamp screws
[4]
of the
top triple clamp and turn steering stem bolt clockwise
[5]
until there is no
more play. Don’t tighten the steering stem bolt all the way, otherwise the bear-
ings will be damaged. With a plastic hammer, lightly rap on the triple clamp
to avoid tension. Re-tighten the five clamp screws with 20 Nm.
IF THE STEERING HEAD BEARING IS NOT ADJUSTED TO BE FREE OF PLAY, THE
MOTOR-CYCLE WILL SHOW AN UNSTEADY DRIVING PERFORMANCE AND CAN GET
OUT OF CONTROL.
IF YOU DRIVE WITH PLAY IN THE STEERING HEAD BEARING FOR LONGER PERI-
ODS, FIRST THE BEARINGS AND THEN THE BEARING SEATS IN THE FRAME WILL
BE DESTROYED.
At least once a year, the steering head bearings should be greased.
3
2
1
4
5
4
4