KTM 640 LC4 Adventure, Руководство пользователя

Страница: 36 / 59

ENGLISH
35
Exchanging the brake light and tail light bulb
Remove the cap 1 on the underside of the license plate retainer.
Turn the lamp socket 2 approximately 30° counterclockwise and pull it out
of the tail light housing.
Slightly depress the bulb, turn it approx. 30° counterclockwise and pull it
out of the socket.
To mount the lamp reverse the worksteps indicated above.
NOTE: Since the bulb on the tail end is subjected to higher vibrations,
heavy-duty bulbs are available from your KTM dealer.
Removing the tank *
Removing the seat (see page 22)
Removing the headlight mask (see page 34)
Close the auxiliary fuel cocks (turn in a clockwise direction) and the fuel
cock (OFF position).
Close the fuel lines to the 3 fuel cocks.
Unplug the plug connector
3
to the gasoline level sensor.
!
CAUTION
!
T
HE GASOLINE LEVEL SENSOR WILL BE DAMAGED IF THE PLUG CONNECTOR
3
IS NOT
UNPLUGGED WHEN YOU REMOVE THE TANK
.
Remove the collar nut 4 and washers.
Lift the rear tank 10-12 cm and lift off.
Mount the tank carefully. Mount the insulating disk, steel disk and collar
nut and tighten. Connect the fuel lines and open the fuel cocks. Connect
the plug and socket connector for the gasoline level sensor and fix to the
fuel lines with cable clips.
NOTE:
The line leading to the fuel pump must be connected to the fuel cock.
Mount the headlight mask (see page 34).
Mount the seat (see page 22).
1
2
3
4