background image

ENGLISH

3

Starting when the engine is cold

1 Open the fuel tap.
2 Turn on the ignition (ignition key position: 

).

3 Switch the gear to neutral (green lamp 

1

lights).

4 Switch on the emergency off switch 

2

(symbol 

must be visible).

5 Operate the choke lever 

3

6 Operate the starter tip switch 

5

without accelerating.

7 If the engine starts, push the choke lever back a little bit, as soon as the

engine runs unevenly.

8 Swing up the centerstand

WARNING

D

O NOT START THE ENGINE AND ALLOW IT TO IDLE IN A CLOSED ROOM

. E

XHAUST

FUMES ARE POISONOUS AND CAN CAUSE LOSS OF CONSCIOUSNESS AND DEATH

. A

LWAYS

PROVIDE ADEQUATE VENTILATION WHILE THE ENGINE IS RUNNING

.

!

CAUTION

!

– M

AXIMUM PERIOD FOR CONTINUOUS STARTING

: 5 

SECONDS

. W

AIT AT LEAST

5

SECONDS BEFORE TRYING AGAIN

.

– D

ON

T RIDE YOUR MOTORCYCLE WITH FULL LOAD AND DON

T REV ENGINE WHEN

COLD

. B

ECAUSE THE PISTON IS WARMING UP FASTER THAN THE WATER COOLED

CYLINDER

IT CAN CAUSE ENGINE DAMAGE

. A

LWAYS KEEP IN MIND THAT THE ENGINE

SHOULD BE WARMED UP WITH SMALL LOAD AT MEDIUM R

.

P

.

M

.

IF THE ENGINE IS DOES NOT CRANK WHEN YOU ACTUATE THE 
STARTER TIP SWITCH:
– the transmission is switched to idle
– Check if the emergency OFF switch is on
– Check if the ignition is on
– the headlight is on (ignition lock in position 

).

– If this is not the case, the battery is discharged
– If the lights are on, proceed as described in the „Trouble-shooting“

section or contact a KTM dealer.

IF THE ENGINE CRANKS BUT DOES NOT START, WHEN YOU ACTUATE
THE STARTER TIP SWITCH:
– Check if the fuel tap is open
– Check if the choke lever has been operated
– Check if sufficient fuel is in the tank

– If this is not the case, refill the tank
– if sufficient fuel is in the tank,  proceed as described in the „Trouble-

shooting“ section or contact a KTM dealer.

NOTE:
T

HIS MOTORCYCLE IS EQUIPPED WITH A SAFETY STARTER SYSTEM

. T

HE ENGINE CAN ONLY

BE STARTED WHEN THE TRANSMISSION IS SWITCHED TO IDLE OR THE CLUTCH LEVER IS
PULLED

RESPECTIVELY

.

THE ELECTRIC STARTER DOESN’T CRANK THE ENGINE WHEN THE STAR-
TER TIP SWITCH IS OPERATED EVEN THOUGH SUFFICIENT ELECTRIC
CURRENT IS AVAILABLE:
– Pull the hand decompression lever 

6

, start and release the lever.

Starting when the engine is warm or hot

1 Open the fuel tap.
2 Turn on the ignition (ignition key position: 

).

3 Switch the gear to neutral (green lamp 

1

lights).

4 Switch on the emergency off switch 

2

(symbol 

must be visible).

5 Operate the starter switch 

5

without accelerating.

6 Swing up the centerstand

What to do when the engine is „flooded”

The throttle must be fully opened when starting. If necessary change spark
plug.

2

5

3

6

1

Содержание 640 ADVENTURE1999














Отзывы: