KTM 50 SX 2012, Инструкции по установке

Страница: 5 / 12

SETUP
3
2.1
Unpacking and setting up the vehicle
700538-01
–
Open the box.
Info
To avoid damaging the vehicle during assembly, do not remove the protec-
tive plastic from a part until just before mounting it and leave the plastic
sheeting on the vehicle until work is completed.
–
Remove the separate enclosure and unpack it. Check that the scope of delivery is
complete on the basis of the enclosed packing list.
–
Lift the vehicle out of the box with the help of another person.
–
Raise the motorcycle with a lift stand. ( p. 4)
–
Check the vehicle for transport damage.
–
Remove the protective plastic from the handlebar.
700539-01
–
Position the handlebar with the handlebar clamps.
–
Mount and tighten the screws.
Guideline
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
–
Check the handlebar position.
» If the handlebar position is not adjusted as the customer requires:
–
Adjust the handlebar position.
x
( p. 4)
–
Check the wiring harness, throttle cables and brake line for free movement and cor-
rect routing.
–
Check that all controls on the handlebar are in the correct location and seated
firmly.
700540-01
–
Mount the footrests with the springs and bolts. Secure the bolts using the washers
and pins.
Pliers for footrest spring (58429083000)
(50 SX)
–
Install the chain guard. ( p. 5)
–
Fill up with fuel. ( p. 5)
(50 SX Mini)
–
Fill up with oil. ( p. 6)
–
Remove the motorcycle from the lift stand. ( p. 4)
–
Rest the vehicle on the plug-in stand.
–
Print out the current PDI form found on KTM DEALER.NET and perform the delivery
inspection.