SET
‑
UP
4
Info
The upper milled groove in the fork leg must be flush with the top edge
of the upper triple clamp.
Position bleeder screws
toward the front.
101034-10
–
Mount the handlebar.
The scale on the handlebar should be at the center of the handlebar clamp.
–
Position the handlebar clamps. Mount and tighten the screws.
Guideline
Screw, handlebar clamp
M8
20 Nm
(14.8 lbf ft)
600816-10
–
Position the controls on the right half of the handlebar.
Info
The routing of the cables can be seen in the figure.
600817-10
–
Position the controls on the left half of the handlebar.
Info
The figure shows how to route the clutch line and wiring harness.
600818-10
(all EXC models)
–
Attach the retaining bracket for the connector, the turn signal bracket with the
turn signal and the speedometer to the upper triple clamp.
Guideline
Remaining screws, chassis
M6
10 Nm
(7.4 lbf ft)
–
Connect the connector.
600819-10
(XC
‑
W SIX DAYS)
–
Attach the speedometer to the upper triple clamp.
Guideline
Remaining screws, chassis
M6
10 Nm
(7.4 lbf ft)
–
Connect the connector.
