2
SETUP
4
K00686-01
–
Route the clutch line with the clutch master cylinder toward the front between the
upper and lower triple clamps.
S00867-14
–
Position the fork legs and tighten the screws of the triple clamp.
Guideline
Screw, top triple clamp
M8
17 Nm
(12.5 lbf ft)
Screw, bottom triple clamp
M8
12 Nm (8.9 lbf ft)
The air release screw
3
of the right fork leg is positioned to the front.
The left fork leg valve
A
is positioned approx. 20 ° further forward.
Info
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
The air suspension is located in the left fork leg. The pressure and rebound
damping is located in the right fork leg.
Position the bleeder screw of the right fork leg and the valve of the left fork
leg facing forward.
K00620-11
–
Remove screws
4
. Remove the handlebar clamp. Remove the handlebar and lay it
to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
5
. Take off handlebar supports
6
.
–
Position rubber bushings
7
and push through nuts
8
from below.
–
Place the handlebar supports in the required position.
Info
The handlebar supports are longer and higher on one side.
Position the left and right handlebar supports evenly.
–
Mount and tighten screws
5
.
Guideline
Screw, handlebar support
M10
40 Nm
(29.5 lbf ft)
Loctite
®
243™
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
