11
SERVICE WORK ON THE CHASSIS
56
Main work
–
Check the throttle cable routing. (
102184-11
–
Position the fuel tank and fit the two spoilers to the sides of the radiator bracket.
–
Make sure that no cables or throttle cables are trapped or damaged.
–
Attach the hose to the fuel tank breather on the tank lid.
–
Mount and tighten screw
with the rubber bushing.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
102183-11
–
Mount and tighten screws
with the collar bushing.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
M00781-11
–
Plug in the connector
for the fuel pump.
–
Remove the wash cap set. Thoroughly clean the plug-in connection of the fuel line
using compressed air.
Info
Under no circumstances should dirt enter into the fuel line. Dirt in the fuel
line clogs the injection valve!
–
Lubricate the O-ring and connect the plug-in connection
for the fuel line.
Info
Route the cable and fuel line at a safe distance from the exhaust system.
Finishing work
–
Mount the seat. (
11.34
Checking for chain dirt accumulation
400678-01
–
Check the chain for coarse dirt accumulation.
» If the chain is very dirty:
–
Clean the chain. (
11.35
Cleaning the chain
Warning
Danger of accidents
Oil or grease on the tires reduces the road grip.
–
Remove the lubricant from the tires using a suitable cleaning agent.
Warning
Danger of accidents
Oil or grease on the brake discs reduces the braking effect.
–
Always keep the brake discs free of oil and grease.
–
Clean the brake discs with brake cleaner when necessary.