KTM 250 EXC-F AUS, Руководство пользователя

Страница: 51 / 117

SERVICE WORK ON THE CHASSIS
49
100802-12
–
Position the brake calipers. Mount and tighten screws

.
Guideline
Screw, front brake caliper M8 25 Nm
(18.4 lbf ft) Loctite ® 243™
–
Mount cable clip

.
–
Position the brake line, wiring harness and clamp. Mount and tighten screws

.
–
Install the front fender. ( p. 51)
–
Refit the headlight mask with the headlight. ( p. 79)
–
Install the front wheel.
x
( p. 71)
–
Check that the wiring harness, cables, and brake and clutch lines can move freely
and are routed correctly.
–
Check the steering head bearing play. ( p. 49)
10.15
Checking the steering head bearing play
Warning
Danger of accidents Unstable vehicle handling from incorrect steering head bearing play.
–
Adjust the steering head bearing play without delay. (Your authorized KTM workshop will be glad to help.)
Info
If the bike is ridden with play in the steering head bearing, the bearing and the bearing seats in the frame can become dam-
aged over time.
–
Raise the motorcycle with the lift stand. ( p. 42)
400738-11
–
Move the handlebar to the straight-ahead position. Move the fork legs to and fro in
the direction of travel.
No play should be noticeable in the steering head bearing.
» If there is noticeable play present:
(EXC
‑
F Factory Edition, EXC
‑
F SIX DAYS, XCF
‑
W SIX DAYS)
–
Adjust the play of the steering head bearing.
x
( p. 49)
(EXC
‑
F EU/AUS)
–
Adjust play of the steering head bearing.
x
( p. 50)
–
Move the handlebar to and fro over the entire steering range.
The handlebar must be able to move easily over the entire steering range. No
resting locations should be noticeable.
» If click positions are noticeable:
(EXC
‑
F Factory Edition, EXC
‑
F SIX DAYS, XCF
‑
W SIX DAYS)
–
Adjust the play of the steering head bearing.
x
( p. 49)
(EXC
‑
F EU/AUS)
–
Adjust play of the steering head bearing.
x
( p. 50)
–
Check the steering head bearing and replace if required.
–
Remove the motorcycle from the lift stand. ( p. 42)
10.16
Adjusting the play of the steering head bearing
x
(EXC
‑
F Factory Edition, EXC
‑
F SIX DAYS, XCF
‑
W SIX DAYS)
–
Raise the motorcycle with the lift stand. ( p. 42)
800022-10
–
Loosen screws

. Remove screw

.
–
Loosen and retighten screw

.
Guideline
Screw, top steering head M20x1.5 10 Nm (7.4 lbf ft)
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
–
Fully tighten screws

.
Guideline
Screw, top triple clamp M8 17 Nm
(12.5 lbf ft)