WORK 3
21
V00469-11
–
Position the headlight mask and secure it with rubber
straps
2
.
The holding lugs engage in the fender.
–
Position the brake line and wiring harness in the brake line
guide.
Finishing work
–
Check the headlight setting. (
3.5
Checking the headlight setting
400726-10
–
Position the vehicle upright on a horizontal surface in front of
a light wall and make a marking at the height of the center of
the low beam headlight.
–
Make another mark at a distance
B
under the first marking.
Guideline
Distance
B
5 cm (2 in)
–
Position the vehicle vertically at a distance
A
away from the
wall.
Guideline
Distance
A
5 m (16 ft)
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the
lower mark for a motorcycle with rider.
» If the boundary between light and dark does not meet
specifications:
–
Adjust the headlight range. (
3.6
Adjusting the headlight range
Preparatory work
–
Check the headlight setting. (
V00369-10
Main work
–
Loosen screw
1
.
–
Adjust the headlight range by pivoting the headlight.
Guideline
The boundary between light and dark must be exactly on the
lower mark for a motorcycle with rider (instructions on how
to apply the mark: Checking the headlight setting).