12
SERVICE WORK ON THE CHASSIS
59
101326-10
–
Position the brake caliper and mount and tighten screws
4
.
Guideline
Screw, front brake caliper
M8
25 Nm
(18.4 lbf ft)
Loctite
®
243™
–
Mount cable binder
5
.
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws
6
.
Finishing work
–
Install the front wheel.
–
Refit the headlight mask with the headlight. (
–
Check the headlight setting. (
12.9
Removing the fork protector
x
Preparatory work
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
101327-10
Main work
–
Remove screws
1
on the left fork leg. Remove the fork protector upwards.
–
Remove the screws on the right fork leg. Remove the fork protector upwards.
12.10
Installing the fork protector
x
101327-10
Main work
–
Position the fork protector on the left fork leg. Mount and tighten screws
1
.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
–
Position the fork protector on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
Finishing work
–
Install the fork legs.
x
–
Install the front wheel.
–
Refit the headlight mask with the headlight. (
–
Check the headlight setting. (
12.11
Removing the lower triple clamp
x
(EXC
‑
F EU, EXC
‑
F AUS, XCF
‑
W)
Preparatory work
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove the front fender. (
–
Remove the handlebar cushion.