KTM 2013 450 Rally Factory Replica, Руководство пользователя, Страница: 86 / 126

17 SERVICE WORK ON THE ENGINE
84
17.1 Checking the engine oil level
Info
The engine oil level can be checked when the engine is cold or warm.
Preparatory work
–
The motorcycle is positioned on a horizontal surface.
400212-10
Condition
The engine is cold.
–
Check the engine oil level.
The engine oil level is up to the bottom edge
A
of the level viewer.
» If the engine oil is not up to the bottom edge of the level viewer:
–
Add engine oil. ( p. 86)
Condition
The engine is at normal operating temperature.
–
Check the engine oil level.
Info
After switching off the engine, wait a minute and then check.
The engine oil level is up to the top edge of the level viewer
B
.
» If the engine oil is not up to the top edge of the level viewer:
–
Add engine oil. ( p. 86)
17.2 Changing the engine oil and oil filter, cleaning the oil screen
x
Warning
Danger of scalding Engine oil and gear oil get very hot when the motorcycle is ridden.
–
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard
Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Drain the engine oil only when the engine is warm.
Preparatory work
–
Park the motorcycle on a level surface.
601320-10
Main work
–
Place a suitable container under the engine.
–
Remove oil drain plug
1
with the seal ring.
601321-10
–
Loosen screw plug
2
by striking it lightly with a hammer a few times.
–
Remove plug
2
with oil screen
3
and the O-rings.
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surfaces.
–
Mount and tighten screw plug
2
with oil screen
3
and the O-rings.
Guideline
Plug, oil screen M32x1.5 30 Nm
(22.1 lbf ft) Lubricated with
engine oil