ENGLISH
7
OPERATION INSTRUMENTS
»
Hand brake lever
The basic position of the hand brake lever can be modified by turning the
adjusting screw
[1]
. This lets you adapt the position of the pressure point (the
resistance you feel on the hand brake lever when the brake pads are pressed
against the brake disk) to fit any hand.
Adjustment of the hand brake lever position is only possible within certain
limits. only turn the adjusting screw manually and never apply excessive
force.
Replacing the front brake pads *
Remove the lock clip. Press the bar on the lock spring [2] while you slide the
bolt [3] from the bracket.
Remove the brake pads
[4]
from the brake caliper and thoroughly clean the
brake caliper with compressed air. Mount the brake pads. Mount the lock spring
[2] and bolt [3] and hold in place with the lock clip.
It is very important to keep the brake disk free from oil and fatty matters.
Otherwise, the braking effect would be strongly reduced.
After working on the braking system, always actuate the hand brake lever or
foot brake lever, respectively to ensure that the brake pads will lie against the
brake disk and the pressure point is established.
MAINTENANCE WORK ON CHASSIS AND ENGINE
»
1
3
2
4
