KTM 125 SX 2018, Инструкции по установке

Страница: 6 / 21

2 SETUP
4
402051-01
–
Position the vehicle on a lift stand.
–
Check the vehicle for transport damage.
A00001-11
–
Remove the cardboard from around the shock absorber.
–
Position the angle lever and linkage lever.
–
Mount and tighten fitting
1
.
Guideline
Nut, linkage lever
to angle lever M14x1.5 80 Nm (59 lbf ft)
–
Mount and tighten screw
2
.
Guideline
Screw, bottom
shock absorber M10 60 Nm (44.3 lbf ft)
Loctite ® 2701™
Info
Raise the wheel slightly to be able to mount the
screw more easily.
–
Route the clutch line with the clutch master cylinder
toward the front between the upper and lower triple
clamps.
–
Install the fork legs. ( p. 8)
K00620-10
–
Remove screws
3
. Take off the handlebar clamp. Remove
the handlebar and lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
4
. Take off handlebar supports
5
.
–
Position rubber bushings 6 and push through nuts 7 from
below.
–
Place the handlebar supports in the required position.
Info
The handlebar supports are longer and higher on one
side.
Position the left and right handlebar supports evenly.
–
Mount and tighten screws
4
.
Guideline
Screw, handle-
bar support M10 40 Nm (29.5 lbf ft)
Loctite ® 243™
–
Position the handlebar.