KTM 125 SX 2011, Инструкции по установке

Страница: 6 / 17

SET
‑
UP
4
0 0 2 2
0 0 1 1
0 0 2 2
1 1
B00375-10
–
Remove screws

. Remove the handlebar clamp.
–
Remove screws

. Remove the handlebar support.
–
Place the handlebar support in the required position. Mount and tighten screws

.
Guideline
Screw, handlebar support M10 40 Nm
(29.5 lbf ft)
Loctite ® 243™
Info
Position the left and right handlebar supports evenly.
600824-10
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount and tighten the screws.
Guideline
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
Info
The markings on the handlebar should be at the center of the handlebar
clamps.
Keep the gap widths equal when tightening.
B00092-01
–
Position the controls on the right half of the handlebar.
Info
The routing of the cables can be seen in the figure.
B00093-01
–
Position the controls on the left half of the handlebar.
Info
The figure shows how to route the clutch line and wiring harness.
–
Install the front fender. ( p. 7)
–
Correctly mount the fuel tank breather.
B00539-01
–
Secure the handlebar cushion with two cable binders.
–
Install the start number plate. ( p. 7)