KTM 1190 RC8 R Track, Руководство пользователя

Страница: 69 / 127

BRAKES
67
11.4
Checking the front brake fluid level
Warning
Danger of accidents Failure of the brake system.
–
If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Check the brake system and do not continue riding. (Your authorized KTM RC8 workshop will be pleased to help.)
Warning
Danger of accidents Reduced braking effect caused by old brake fluid.
–
Change the brake fluid of the front and rear brake according to the service schedule. (Your authorized KTM RC8 workshop
will be pleased to help.)
601448-10
–
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
–
Check the brake fluid level in the brake fluid reservoir

.
» If the brake fluid is below the MIN marking:
–
Add front brake fluid.
x
( p. 67)
11.5
Adding brake fluid of front brake
x
Warning
Danger of accidents Failure of the brake system.
–
If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Check the brake system and do not continue riding. (Your authorized KTM RC8 workshop will be pleased to help.)
Warning
Skin irritation Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
If brake fluid comes into contact with the eyes, flush the eyes thoroughly with water and consult a physician immediately.
Warning
Danger of accidents Reduced braking effect caused by old brake fluid.
–
Change the brake fluid of the front and rear brake according to the service schedule. (Your authorized KTM RC8 workshop
will be pleased to help.)
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Never use DOT 5 brake fluid! It is silicone-based and purple in color. Oil seals and brake lines are not designed for DOT 5
brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid is corrosive and will damage painted surfaces.
Use only clean brake fluid from a sealed container!
601449-10
–
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
–
Loosen screw.
–
Remove cap

with membrane

.
–
Add brake fluid to the MAX level.
Brake fluid DOT 4 / DOT 5.1 ( p. 118)
–
Position the cap with the membrane. Mount and tighten the screws.