SET
‑
UP
3
2SET‑UP
2.1
Unpacking and setting up the vehicle
–
Remove the cardboard packing material.
700354-01
–
Remove the adhesive tape at the top of the motorcycle.
700355-01
–
Roll down the plastic sheeting on the sides.
Info
To avoid damaging the motorcycle while unpacking it, leave the remaining
plastic sheeting on the motorcycle until you have finished.
–
Remove the separate enclosure from the seat.
–
Unpack the separate enclosure and check its contents on the basis of the enclosure
list.
–
Check the vehicle for transport damage.
700356-01
–
Remove plastic
from the handlebar stubs.
–
Remove screw
with distance sleeve
from both handlebar stubs.
–
Adjust the handlebar height. (
Info
Mount the handlebar stubs in the low position.
700357-01
–
Remove the side screws
on the left holder.
–
Remove the top screws
on the left holder.
–
Loosen the holder from the base frame in an upward direction.
700358-01
–
Remove the side screws
on the right holder.
–
Remove the top screws
on the right holder.
–
Leave the holder on the base frame.
Info
The motorcycle is leaning toward the right and is resting against the holder
on the base frame.
