-13-
Duplex Mode Setting
The duplex mode used for the fiber module is configured by the DIP
SW W5 and W6 which are located on the rear panel of the unit. See
next section for more information.
Specifications
Standard
IEEE 802.3u 100Base-FX
Speed
100Mbps
Duplex mode
Full duplex or half duplex
Wavelength
1300nm
Fiber Connectors
ST, SC, MTRJ, VF45
Fiber cable
MM 50/125mm, 62.5/125mm recommended
SM 9/125mm recommended
Module Installation
1. Turn off the power to the switch unit.
2. Open the cover of fiber slot.
3. Configure the fiber jumpers on the module to enable fiber connection.
4. Insert the module into slot until it is seated properly.
5. Screw the module onto the chassis securely.
