function via software management to set forced mode and specify speed and duplex mode which match the
configuration used by the connected device.
2.8 Making Fiber Connection
The SFP slot must be installed with an SFP fiber transceiver for making fiber connection. Your switch may
come with some SFP transceivers pre-installed when it is shipped.
Installing SFP Fiber Transceiver
To install an SFP fiber transceiver into SFP slot, the steps are:
1. Turn off the power to the switch.
2. Insert the SFP fiber transceiver into the SFP slot. Normally, a bail is provided for every SFP transceiver.
Hold the bail and make insertion.
3. Until the SFP transceiver is seated securely in the slot, place the bail in lock position.
Connecting Fiber Cables
LC connectors are commonly equipped on most SFP transceiver modules. Identify TX and RX connector
before making cable connection. The following figure illustrates a connection example between two fiber
ports:
Make sure the Rx-to-Tx connection rule is followed on the both ends of the fiber cable.
Network Cables
Multimode (MMF) - 50/125
μ
m, 62.5/125
μ
m
Single mode (SMF) - 9/125
μ
m
Fiber Port Configuration
For 100M fiber application on Port 7, use
100M_Full
port configuration for fiber connection.
For 1000M fiber application on Port 8, just leave the default port configuration
Auto
for fiber connection.
-19-
Содержание KGS-0820
Страница 36: ...4 4 System 36 ...