1. CAUTIONS
3
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
Note
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
WARNING
This is a class A product. In a domestic environment this product may cause
radio interference in which case the user may be required to take adequate
measures.
Caution
Any changes or modifications in construction of this device which are not
expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
1. A regulated DC12V or AC24V power supply with a minimum of 500mA / 10VA is
recommended for use with this product for the best picture and the most stable operation.
An unregulated power supply can cause damage to the product.
If an unregulated power supply is used, product warranty will be void.
2. It is recommended that cables and monitors with a 75ohm video impedance level are
used with this product.
If your monitor supports high impedance mode, then please adjust accordingly.
3. Do not disassemble the camera to gain access to the internal components.
Refer servicing to your dealer.
4. Pointing the camera directly towards the sun, or any similarly bright or reflective light,
may cause smear and possible damage to the sensor.
5. Removing the Serial Number Label will void the warranty.
6. The camera’s power supply must be plugged into a properly grounded wall socket.