background image

3. Product Description

Description and function

LED Type: 
KNC-HNDi100, KNC-HNDi120

Standard Type: 
KNC-HDDi100, KNC-HDDi120

1. Infrared LED – These LEDs emit infra red radiations. 
2. Reset Button – Press the reset switch for more than 10 seconds,
                               the restore the camera to the function default settings.
3. Service Video Connector – Outputs video to the monitor.
4. Power Input(DC12V) – Connect DC 12V power.
5. Network Connector – 
The Network Camera connects to the network via a standard network cable, and 
automatically detects the speed of the local network segment
(10BaseT/100BaseTX Ethernet). PoE Supported

3-Axis Gimbal

M170-HD(N)Di100/120-001

Megapixel Network Camera

KNC-HDDi100 / KNC-HNDi100
KNC-HDDi120 / KNC-HNDi120

Installation Guide

Table of Contents

1.INTRODUCTION

2.PACKAGE CONTENTS

3.PRODUCT DESCRIPTION

4.INSTALL THE HARDWARE

5.ASSIGN AN IP ADDRESS

6. PRODUCT SPECIFICATIONS

1. Introduction

KNC-HDDi100, KNC-HNDi100, KNC-HDDi120, KNC-HNDi120 Installation Guide

This  installation  guide  provides  instructions  for  installing  the  Network  Camera  on  your 
network.  For  all  other  aspects  of  using  the  product,  please  see  the  User’s  Manual, 
available on the CD included in this package, or from http://www.ktnc.co.kr

Installation steps

1. Check the package contents against the list below.
2. Product description.
3. Install the hardware.
4. Set an IP address.
5. Set the admin and user ID and password, See User’s Manual.

I m p o r t a n t !

This product must be used in compliance with local laws and regulations.

2. Package Contents

Network Camera

Video Output Test Cable

Software CD

Installation Guide

Template

Screws

4. Install the hardware

KNC-HDDi100, KNC-HNDi100, KNC-HDDi120, KNC-HNDi120 are designed to be installed using a 
template as shown below. 

1. Template – To mount the camera.
2. Screws(3ea) - To secure the camera to the template.

Connection

1. Connect the camera to the network using a UTP cable (CAT.5), Power can be supplied via 
    the network cable (PoE)
2. Connect DC 12V to the power terminal. This is not necessary if the Network Camera is 
    connected to PoE hub or midspan.
3. Check that the indicator LEDs indicates the correct conditions.
4. Connect the analog monitor to the service video connector for adjusting focus and press and quickly 
    release the reset switch for focus assistant mode. 
    Then you can select normal view or focus view mode using the reset switch.

Caution: When you use focus assistant mode, “Focus View” mode is recommended for more exact focus.
Caution: Focus assistant mode will be automatically exited after 3 minutes for normal operation.

Dimensions

Pan Rotation

Horizontal Rotation

Tilt Rotation

CAUTION 

panning(Pan + Horizontal) the bracket in excess of 1 rotations in one direction
may cause damage to the cable.

CAUTION 

Tilt Rotation - LED Type: Viewable operation tilt angle 50˚

                      Standard Type: Viewable operation tilt angle 70˚

Ø108.5

Ø100

Ø135

45

96.9

Standard Type

(Sunshield Cover)

LED Type

(LED Cover)

Отзывы: