ADJUST VOLUME
ADJUST DISPLAY BRIGHTNESS
5
BATTERY BACK-UP
(For Temporary Time Storage Only)
Install
2XAA/LR06/UM3 battery (not included) according to polarity shown inside the battery
compartment. In the event of a power interruption, your set will not work normally from the
mains supply but there is now the advantage that your clock will continue to work. The clock
display will not light up, as the clock time will be held in the memory. This also enables you to
move the set from place to place without re-setting the clock every time. The battery back-up
system is only meant to be used from short temporary power interruption. For longer durations,
the battery may become exhausted or there may be some deviation in accuracy. When the
battery is exhausted, it should be removed from the set to prevent leakage. If you do not wish to
take advantage of the battery back-up system, your set will work normally without a battery.
However, if disconnected from the mains, the clock figures will flash when the mains are
re-connected and you must re-set the clock as described in the Electronic Clock Operation
paragraph.
Attention should be drawn to the environmental aspects of battery disposal. Don’t throw used
batteries in dustbin. Please contact your retailer in order to protect the environment.
Attention should be drawn to the environmental aspects of battery disposal.
Electrical products should not be disposal of with household waste. Please recycle where
facilities exist. Check with your Local Authority of retailer for recycling device.
(Batteries pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire
or the like.
SPECIFICATION
Power Source : AC 110-240V ~50/60Hz VDE External adapter
Tuner Range : FM 87.5-108.0MHz
Power Consumption : 5W
Product information is subject to change without prior notice.
USB Charging
To Connect your cell phone for charging :
Use a USB cable (not included) to connect your cell phone to the USB connector or
the unit. Your cell phone should start charging.
Use the USB charging port to charge your smartphone or to power USB powered
devices such as a USB type lamp or fan.
Remarks :
Charging function may not be supported for all phones or electronic devices
During standby mode, Press and hold DIMMER for 2 seconds repeatedly to select
high or low brightness levels.
While listening, press + VOLUME – to adjust volume.
USB Charging power : DC 5V 1A ( standby mode )
