KSV SPOT
KSV SPOT Manual
Rev. 1.0
7
5. Installing the KSV SPOT
Make sure that all parts needed to install KSV SPOT have been received. Use the checklist
below.
•
KSV SPOT measuring head
•
Counter electrode made of stainless steel
•
Stand for SPOT
•
Cable for connecting the measuring head and counter electrode (crocodile clip – RCA
cable)
•
15-pin device cable for connecting SPOT measuring head to LayerBuilder unit
•
CD-ROM disk for installing the SpotMonitor software and User’s Manual in pdf
format
5.1. Installation steps
The KSV SPOT measuring head is controlled by a Window 2000/XP/Vista compatible
software.
5.1.1. KSV SPOT software
The SpotMonitor software is supplied on a CD-ROM disk. Load the software onto the desired
drive using normal Windows procedures.
NOTICE! This software needs to be installed only if the KSV SPOT is intended to be used as
a stand-alone unit.
If the KSV SPOT is intended to be used in combination with KSV´s monolayer troughs the
software for controlling the KSV SPOT will be integrated in the LB software. In this case
there is no need to install KSV SPOT Monitor software. Measurement procedures will be
described in section 6.2.
5.1.2. Connecting cables
The KSV SPOT measuring head is connected to the LayerBuilder Unit with 15-pin cable and
to the counter electrode with a crocodile clip - RCA cable. The image below shows where the
15-pin cable and the crocodile clip – RCA cable should be connected.
