Setting the Inverter ID
The inverter ID is used to identify the inverter in a RS485 connection.
We set a different inverter ID for each inverter in the PV plant to identify the inverters correctly. On the last
inverter in the RS485 connection, switch on the RS485 termination resistor.
Option 5 under Settings Menu- 485 address
Set Date and Time of Inverter
Date and time have to be correct for a precise calculation of the statistics in the inverter itself and in a
monitoring system.
Option 10 under Settings Menu- Date/Time
Set communication protocol
Option 7 under Settings Menu- 485 Protocol
NOTE: The above details are mentioned in the
Installation & Operation Manual
for Kstar KSG
30K/36K/50K/(60K- HV)/60K on Page 28.
Set correct Inverter IDs
Set correct Date and Time
Press UP/DOWN to increase or decrease the input figure,
confirm input and return back setup interface by pressing
ENTER button, press ESC button to cancel input and return
back setup interface.
l value is between 1 and 32.
The input numerical value is between 1 and 32.
Press UP/DOWN to increase or decrease the input figure; press
ENTER button to move the cursor backwards, confirm input
and return back setup interface and move the cursor
frontward and return back setup interface by pressing ESC
button.
Press UP and DOWN to move corresponding options. Confirm
selected option and return back the setup interface by
pressing ENTER button. Press ESC button to cancel choice and
return back the setup interface.