code R30023.110en www.kseniasecurity.com
ed.05/2020
DESCRIPTION OF THE KEYPAD
STEP 3. CABLING AND SWITCHING ON
1. Connect the cables to the terminals on the rear of the keypad.
2. Close the keypad properly (4).
3. At every new installation when ergo wls is switched on (but not wire to BUS [A and B] clamps
disconnected), the display will show the following information:
• First line: “Ksenia Security”
• Second Line: from the first character from the left the FW version loaded on the device (x.xx.xxx),
from the 10th character the device serial-number (six numeric characters) and at the 16th character
“W” to indicate wireless.
Legend
1. Connection Clamps [A B] on KS-BUS (only for
firmware update
2. Anti opening / tamper switch
3. Loudspeakers contact
4. Snap fingers
5. Battery connector
6. Battery pack
7. USB connector (for future use)
Note: DO NOT REMOVE PCB AND DISPLAY FROM
PLASTIC SUPPORT
Legend
1. Alphanumeric keypad with 1 a 9, * and # keys
2. ESC key
3. ENTER key
4. Scroll also including:
4.1. Left arrow
4.2. Down arrow
4.3. Right arrow
4.4. Up arrow
5. Display
6. Audio mic hole (for future use)
7. USB connector (for future use)
