KSB Guard, Инструкция по установке и эксплуатации

Страница: 21 / 40

5 Installation/Commissioning
21 of 40
KSB Guard
5.1.5 Installing the transmission and battery unit
The transmission and battery unit can be freely positioned as long as the transmission
quality to the gateway is sufficient. (
ð Section 5.1.4, Page 20)
WARNING
Work in the immediate vicinity of rotating parts
Risk of hand injury!
▷ Always have this work performed by trained personnel.
▷ Take particular caution when performing this work.
The area selected should have the following properties:
▪
Temperature of substrate ≤ 50 °C
▪ Position protected
▪ Level
▪ Maximum ground clearance 2 m
ü Electrical connection between sensor unit and transmission and battery unit has
been established.
ü Batteries have been inserted. (Supplied condition)
ü Signal strength at installation location is sufficient. ( ð Section 6.2, Page 25)
1. Position the transmission and battery unit such that there is a line of sight to the
gateway if possible. In the process, ensure that the connecting point of the
connecting cable can be easily accessed.
2. Clean the surface of the transmission and battery unit using the supplied alcohol
pads.
3. Securely attach the transmission and battery unit using the supplied fastening
material.
5.1.6 Routing the connecting cable
WARNING
Work in the immediate vicinity of rotating parts
Risk of hand injury!
▷ Always have this work performed by trained personnel.
▷ Take particular caution when performing this work.
WARNING
Hot surfaces (Pump and piping take on the temperature of the fluid handled.)
Risk of burns!
▷
Do not touch hot surfaces.
CAUTION
Improper routing
Damage to the connecting cable!
▷ Never kink or crush the connecting cable.