KSB Guard, Инструкция по установке и эксплуатации

Страница: 12 / 40

4 Description
12 of 40
KSB Guard
Transmission and battery
unit
Table 6: Technical data of transmission and battery unit
Characteristic Value
Material Plastic
Dimensions [mm] 120 x 80 x 50
Enclosure IP65
Temperature range 0-50 °C
Power supply 2 C size batteries (baby), (R14)
Wireless module ISM band, 2.4 GHz
Connection M8, 6-pin
Gateway Table 7: Technical data of gateway
Characteristic Value
Mains voltage 110 - 240 V, AC voltage
Mains frequency 50/60 Hz
Power input < 15 W
In-service ambient temperature 0 to 40 °C
1)
Enclosure IP54
Weight < 400 g
Dimensions 158 × 95 × 45
SMA-RP socket (antenna sensor network) Antenna for 2.4 GHz (WLAN/
Bluetooth)
SMA socket (LTE antenna) Antenna for 2G/3G/4G mobile
data, included in standard
accessories with approx. 5 m
cable
Internal SIM card
2)
Pre-configured
4.4 Function
Transmission and battery
unit
The sensor unit and transmission and battery unit are connected by a connecting
cable. The sensor unit is installed on the pump’s bearing bracket or drive lantern,
where it measures the pump’s vibration and temperature using built-in sensors.
This data is sent to the transmission and battery unit.
The transmission and battery unit sends the recorded data to the gateway via a radio
signal. From there, the data collected is transferred directly and in encrypted format
to the KSB Cloud for processing.
Gateway One gateway can process the data of up to 20 transmission and battery units if they
send data every hour. This number is reduced with more frequent data transmission.
1) Higher temperatures than indicated are possible. Contact KSB Support before installation. Contact: +49 6233 86 6400 and
ksbguard-support@ksb.com.
2) The SIM card is pre-installed and cannot be replaced.