5 Installation at Site
38 of 64
Evamatic-Box N
13. Fasten the power cable.
Protrusions for inserting the screws are provided on the outside of the tank. Use
these precise positions when fitting the clamp holders.
14. Pull the power cable through cable grommet 916 and press the cable grommet
into its seat.
5.5.3 Evamatic-Box N 200 l — stationary version, with Amarex N S 32
Installing the piping
81-73
59-18
710-1
885
13-18
400
45-3
916
Fig. 18:
Installing the piping
1. Cut the cover of the seat for cable grommet 916 open with a 45 mm diameter
hole saw.
2. Debur the edges and smoothen the surface until the diameter equals 46 ±
0.5 mm.
Alternatively, for tanks installed underfloor, the float switch cable can be
guided through the vent nozzle. In this case, do not alter the original condition
of the cable grommet seat.
3. Drill a hole of diameter 25 + 1 mm for fitting PG cable gland 45-3 for the power
cable of the pump (7 × 1.5 mm²). Use the marking in a central position of the
tank provided for drilling the hole.
Alternatively, for tanks installed underfloor, the power cable of the pump can
be guided through the vent nozzle. In this case, do not drill any holes for the PG
cable glands.
NOTE
For fitting PG cable glands 45-3, gasket 400 must be fitted on the outside of the
tank.
4. Fasten clamp holder 81-73 to the tank with the screw supplied for this purpose.
(A protrusion for inserting the screw is provided on the outside of the tank. Use
this precise position when fitting the clamp holder.)
5. Fasten the clamp to clamp holder 81-73 and tighten it.
6. Attach hook 59-18 to the clamp.
7. Fasten the shackle and chain 885 to the pump handle.
8. Lower the pre-assembled piping into the tank and position the baseplate on the
protrusion provided for this purpose.
9. Slide outlet pipe 710-1 into elbow 13-18 until it will not go any further. Secure it
with glue.
10. Attach chain 885 to hook 59-18.
