Krups EA89 Series, Руководство пользователя

Страница: 21 / 42

19
EN
The milk or water is not flowing
correctly into the cup(s).
Check that the One Touch Cappuccino block is correctly positioned.
There are traces of milk in an
Americano or a Hot water. Complete a milk rinsing cycle or dismantle and clean the one touch cappuccino
accessory before running the preparation.
There is water underneath the
appliance.
Before removing the water tank, wait for 15 seconds after the coffee has
finished flowing so that the appliance finishes its cycle properly. Check that the
drip tray is correctly positioned on the machine; it should always be in place,
even when the appliance is not in use. Check that the drip tray is not full.
The drip tray should not be removed during a cycle.
When you turn off the appliance,
warm water flows out of the
coffee outlets and the One Touch
Cappuccino block.
According to the type of recipe prepared, the machine may run an automatic
rinsing cycle when it is turned off. This cycle lasts only a few seconds and
stops automatically.
After emptying the coffee grounds
collector, the warning message is
still displayed on the screen. Correctly replace the coffee grounds collector and follow the instructions on
the screen.
Wait at least 5 seconds before replacing them.
The coffee dispenses too slowly.
Turn the ‘fineness of grind’ adjustment dial to the right to make the ground
coffee coarser (according to the type of coffee used).
Run one or several rinsing cycles.
Run a machine clean (see “Automatic machine cleaning programs p.28).
Change the Claris Aqua Filter System cartridge (see “Installing the filter”) p. 23).
The water tank has been filled,
but the warning message is still
displayed on the screen. Check that the tank is installed correctly on the device.
The float at the bottom of the tank should move freely. Check and unblock the
float if necessary.
The coffee fineness knob is
difficult to turn.
Only change the grinder setting when it is running.
The espresso or coffee is not hot
enough.
Run a coffee circuit rinsing cycle before preparing your coffee.
Increase the coffee temperature in the Settings menu. Warm the cup by rinsing
it with hot water before making the drink.
The coffee is too lightly coloured
or too weak.
Avoid using oily, caramelised or flavoured coffee beans. Check that the coffee
bean container has coffee in it and that is it dispensing correctly.
Decrease the volume of the preparation and increase the strength of your drink
by using the Dark function.
Turn the grinding fineness adjustment dial to the left to make the grounds finer.
Make the drink in two cycles by using the 2 cups function.
The appliance is not producing
coffee. A problem has been detected during preparation of the drink.
The appliance has restarted automatically and is ready for a new cycle.
A power failure occurs during a
cycle.
The appliance will automatically restart when the power is switched back on.
Your tea is not hot enough or too
hot.
Increase or reduce the hot water temperature in the Settings menu.
You have used ground coffee
instead of coffee beans. Use your vacuum cleaner to remove the ground coffee from the coffee bean
container.
Appearance of steam under the lid
of the grain tray.
Close the cleaning tablet chute beneath the cover.
After preparing a drink, if you ask
for an extra shot the machine tells
you that this is not possible. The coffee grounds collector is full and the extra shot function is not available.
Once your drink has been made, you can prepare an espresso after emptying
the coffee grounds collector.
Danger : Only a qualified technician is authorised to carry out repairs on electrical wiring and carry out work on
the electrical grid. If you do not follow these instructions, you risk death by electrocution. Do not use
an appliance that is visibly damaged!