Krowne Metal Corporation
100 Haul Rd. Wayne, NJ 07470 • Toll Free: (800) 631-0442 • Fax: (973) 872-1129
[email protected] • www.krowne.com • www.facebook.com/KrowneMetal • www.twitter.com/KrowneMetal
1. Assemble Pre-Rinse without Add-On Faucet
This step has been completed at the factory.
Proceed to Step 2.
1A. Assemble Pre-Rinse with Add-On Faucet
a.
Remove the Riser Pipe from the Faucet Body.
b. Install Teflon Tape on the threaded section of the
Add-On Faucet. Thread the Add-On Faucet into
the main Faucet Body and tighten.
c. Remove the Teflon Tape from the Riser Pipe
and replace it with new Teflon Tape. Thread the
Riser Pipe into the top of the Add-On Faucet and
tighten.
2. Assemble Wall Bracket Model #21-137
Determine the correct length of the Support Rod from
the wall to the Riser Pipe. Cut the rod. Determine the
position on the wall for the Wall Bracket Base, making
sure that the bracket is near the top of the Riser Pipe
and as close to the Spring Retainer as possible. Install
the Wall Bracket on the wall with the screws included.
Press the end of the Support Rod into the bracket and
install the head of the Support Rod around the Riser.
3. Assemble Pre-Rinse with
Gooseneck Spring
The Pre-Rinse Spray Head, Hose,
Spring, and the Quick Connect Hose
Adapter have been assembled at
the factory to save time. Install the
complete assembly onto the top of
your Riser Pipe, making sure that
you use the small black washer
supplied in the cylinder on the pack-
age board. Hand tighten.
4. Final Assembly and Adjustments
After all parts are in place, tighten all connections with a wrench. Loosen
the Spray Head Hook and center the hook. Tighten the Spray Head Hook.
If you are using the optional Add-On Faucet, make sure that the faucet is
centered with the shut-off valve toward you.
Rev. 09/2011
No. PLUMB-1.00
MOUNTING INSTRUCTIONS for ROYAL SERIES PRE-RINSE ASSEMBLY
The Krowne Royal Pre-Rinse has been pre-assembled to substantially cut installation time. This, coupled with our new
Quick Connect Hose Assembly makes our Pre-Rinse one of the easiest to install in the industry. We will assume that you
have installed the faucet base with the riser in the sink or counter per the instructions on the previous page.
Printed in the USA
CAUTION:
The manufacturer recommends
using the Wall Bracket assembly
to secure the Riser Pipe on all
Pre-Rinse Assemblies.